|
|
Post by richard on Apr 30, 2015 10:47:42 GMT
Some advice please guys - I got the master cylinder cap powder coated, but he coated the outside face AND the inside face. Does anyone think this will cause a problem, either with clearance for the diaphragm or with contamination into the fluid?
Basically i can just take it back and get him to re-do it and i need to know if i should.
Thanks in advance.
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on May 5, 2015 18:16:03 GMT
|
|
|
|
Post by richard on May 5, 2015 18:24:30 GMT
Thanks very much for linking it Nick - bit too pricey in that condition...........I will keep on looking.
|
|
|
|
Post by richard on Jun 4, 2015 19:55:00 GMT
Took the left cover off and found this......should I worry about this level of rust in here?  |
|
|
|
Post by richard on Jun 5, 2015 18:56:49 GMT
Also I moved it when trying to wire brush off the rust. Is it a problem that I moved it round?
|
|
|
|
Post by wazzbo on Jun 5, 2015 19:14:06 GMT
No prob that it moved Richard, it spins when the engine is turning.
If it was mine I would pull off the rotor and have a good clean up.
Dave....
|
|
