|
|
Post by clueless on Jan 30, 2017 15:43:01 GMT
Hello
Any know the diameter clutch removal tool need for the Superdream 400? The Haynes manual simply says to make your own from "thick walled tubing of the correct diameter." And I've lent my vernier out.
thanks.
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Jan 30, 2017 16:26:48 GMT
|
|
|
|
Post by Mike1962 on Jan 31, 2017 16:26:36 GMT
Hello Any know the diameter clutch removal tool need for the Superdream 400? The Haynes manual simply says to make your own from "thick walled tubing of the correct diameter." And I've lent my vernier out. thanks. Hi I bought this one: www.ebay.co.uk/itm/302163753762?_trksid=p2057872.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AITThe guy makes them on a CNC macine - it was a really accurate fit but unfortunately my centre nut would not budge and requires an air driven impact wrench to shift it and luckily my plates all separated so I never needed to use it! But...... it will def do the job Hope this helps MIke |
|
|
|
Post by wazzbo on Feb 1, 2017 10:03:07 GMT
They look a well made tool,me been a cheapskate l made one from a socket.
They are a better thing than Haynes who say make one from a bit of tube, at least with a socket type you can torque them up properly, and if need be use an impact wrench to loosen them.
|
|
|
|
Post by clueless on Feb 1, 2017 19:46:05 GMT
Thanks very much.
Crouchy: I had see that one for sale an think I will probably get it now on your recommendation
Mike: Those look fantastically made but I don't think the guy has any to sell at the moment, I could send him an email I guess.
Wazzbo: I've just upgraded all my sockets to a beautiful shiny new Bahco set and sold off the old ones!
|
|
