tonyvtrf
New Member
Phillip Island. Australia
Posts: 19
|
Post by tonyvtrf on May 28, 2015 0:28:55 GMT
Hi all, wondered if anybody can help! I have an 1981 250n which I have fitted a 1980 400n eng. Now I need to do something about the brakes ie one disc to twin! as there seems to be a shortage of 400n parts in this country (Aust) I seem to be in a bit of a pickle.What I have collected is one nissin cal 6H21 R hand. Pair nissin cal 5N12 R&L one 19" twin disc Front wheel and two disc's I think of a 750/900 CB. And a master cylinder and lines of a bigger bike ie CB 750/900 can you please help. I know I need a R hand slider too Tony
|
|
|
|
Post by na44superdream on May 28, 2015 3:47:20 GMT
The CB750/900 are 276mm diameter? with the lightening slots adjacent the inside edge of the working surface? or solid? Standard cb400n discs are 240mm dia, but the 276mm disc could work fine.
Not sure of you caliper details though? any photos
|
|
tonyvtrf
New Member
Phillip Island. Australia
Posts: 19
|
Post by tonyvtrf on May 28, 2015 13:23:19 GMT
Thanks for the reply, had some further research on this problem, and the difficulty I will have in trying to adapt and modify between models and years seems to be to hard and expensive. sooo I'll take the advise of a mate of mine, and loose some mass and adhere to the speed limit. Fat Tony PS used to Yam 600FZR and Honda 750VTR brakes
|
|
