|
|
Post by gazw on Jul 22, 2014 18:53:11 GMT
After stripping my other superdream down and the new one not having proper rear indicators Ive gone and bought some , but I cant see how they should fit back on and unsure which bolts should go in there
I know they fit to the big hole in the grab rails but how does the bolt fit and how do you tighten them up?
Cheers
|
|
|
|
Post by caprinix1959 on Jul 22, 2014 19:08:34 GMT
The bits you need are-a rubber thingy that fits onto the mounting on the grab rail,a large square spire clip that slides inside the indicator,a little steel tube and the bolt. The rubber goes on the mounting then fit the spire clip into the indicator with the big hole at the bottom. Now the fun bit,you need to lie under the bike a look up,align the hole and put the little tube into the hole. Finally put the bolt in and nip it up NOT TOO TIGHT. The bit I left out is that usually I find that as I reach for the bolt the little tube falls out and you have to start again!!!!!!!
|
|
|
|
Post by caprinix1959 on Jul 22, 2014 19:11:07 GMT
The above bits are available from CMS but arrange a second mortgage as the total is over £40 for these tiny parts with postage
|
|
|
|
Post by jonnyboy on Jul 22, 2014 19:24:32 GMT
keep checking german ebay they do come up from time to time, i bought a set of indicators with the rubber parts and squire clips for £30 including postage!
|
|
|
|
Post by gazw on Jul 22, 2014 19:29:02 GMT
Thanks for the replies
I remember the rubber bits now and the little metal inserts , im sure I still have them all here
Will dig them out and have another go tomorrow
|
|
|
|
Post by Fordy on Jul 22, 2014 20:59:28 GMT
I did mine recently and there wasn't any metal tubes at all, and if you over tighten the plastic easily cracks, as I found out!
|
|
