Post by buster on Aug 25, 2018 12:11:27 GMT
ok went off and got the gas kit for it this morning and set about having a quick play with some scrap. this is the first go with gas
this was a case of getting the set up right, the gas flow was set and then its just a case of getting the wire feed right. this is the second attempt
without blowing my own trumpet too much I’m quite chuffed with that, I think I’v found the set up now just down to practice and technique and as bodie suggested probably the angle grinder for a bit of a tidy. all welding tips would be gratefully recieved (m6 0.8mm semi industrial ta)
this was a case of getting the set up right, the gas flow was set and then its just a case of getting the wire feed right. this is the second attempt
without blowing my own trumpet too much I’m quite chuffed with that, I think I’v found the set up now just down to practice and technique and as bodie suggested probably the angle grinder for a bit of a tidy. all welding tips would be gratefully recieved (m6 0.8mm semi industrial ta)
