|
Post by bigbird on Mar 1, 2021 13:14:31 GMT
Hello. Just been cleaning the rear wheel on my 400n and noticed play in the wheel bearings. It seems that the bearing and spacer tube are a close fit not allowing access to drift the offending bearings out by pushing the tube to one side. Do you have to use a blind hole puller to remove the bearing.
|
|
|
Post by na44superdream on Mar 1, 2021 17:08:15 GMT
Get a bit of round bar or similar, that is exactly 20mm Diameter , position then drive it against the 1.5mm thin bit of spacer at the internal of Sprocket side bearing, Create enough play to allow the other side bearing to have an edge to catch or just drive it all the way out . with some mechanical sympathy . Good luck. p.s. Standard clearance Bearings (not C3)
|
|
|
Post by BruceB on Mar 1, 2021 23:25:33 GMT
In other word use a big hammer
|
|